CCC is going nuts!
Posted:
Thu Jan 17, 2008 8:32 amby MCAntonio aka AN21
When I want to start Catalyst Control Center a message pops up saying:
Could not load or assembly 'CLI.Implementation, Version=2.0.2895.26427, Culture=neutral, PublicKeyToken=90ba9c70f846762e' or one of its dependencies. The system cannot find the file specified.
I tried doing a repair but it doesn't help at all. What is wrong (again as ussual) in my PC???
Re: CCC is going nuts!
Posted:
Thu Jan 17, 2008 12:43 pmby ozzy72
Try installing a new version of .NET (I think it is at 3.5 now), that should cure it
Re: CCC is going nuts!
Posted:
Thu Jan 17, 2008 3:55 pmby MCAntonio aka AN21
Installed it and no results..It displays the same message..
Re: CCC is going nuts!
Posted:
Thu Jan 17, 2008 4:15 pmby waspiflab
Which version are you using??
Latest
http://ati.amd.com/support/driver.htmlsounds like a NET issue.
found this:
After successfully installing the new driver and CCC, I was still unpleasantly surprised with:
Could not load file or assembly
Re: CCC is going nuts!
Posted:
Thu Jan 17, 2008 6:08 pmby MCAntonio aka AN21
Which version are you using??
Latest
http://ati.amd.com/support/driver.htmlsounds like a NET issue.
found this:
After successfully installing the new driver and CCC, I was still unpleasantly surprised with:
Could not load file or assembly [ch8216]CLI.Implementation, Version=2.0.2736.38315, Culture=neutral, PublicKeyToken=90ba9c70f846762e[ch8217] or one of its dependencies. The system cannot find the file specified.
Which was fortunately easily solved by re-installing the WHOLE driver package, including the bundled .NET 2.0 runtime. This was quite strange, as .NET 2.0 was already installed on the system.
Just go into add and remove programs in control panel and find Ati software uninstall utility and click change/remove then reinstall bundle from the link.
hope this helps
waspi
So simple right?It worked! Had to completely uninstall .NET and CCC and reinstall..Thanks guys!