CCC is going nuts!

[MCAntonio aka AN21]

When I want to start Catalyst Control Center a message pops up saying:
Could not load or assembly 'CLI.Implementation, Version=2.0.2895.26427, Culture=neutral, PublicKeyToken=90ba9c70f846762e' or one of its dependencies. The system cannot find the file specified.
I tried doing a repair but it doesn't help at all. What is wrong (again as ussual) in my PC???

[ozzy72]

Try installing a new version of .NET (I think it is at 3.5 now), that should cure it

[MCAntonio aka AN21]

Installed it and no results..It displays the same message..

[waspiflab]

Which version are you using??

Latest
http://ati.amd.com/support/driver.html
sounds like a NET issue.

found this:
After successfully installing the new driver and CCC, I was still unpleasantly surprised with:

Could not load file or assembly

[MCAntonio aka AN21]

Which version are you using??

Latest
http://ati.amd.com/support/driver.html
sounds like a NET issue.

found this:
After successfully installing the new driver and CCC, I was still unpleasantly surprised with:

Could not load file or assembly [ch8216]CLI.Implementation, Version=2.0.2736.38315, Culture=neutral, PublicKeyToken=90ba9c70f846762e[ch8217] or one of its dependencies. The system cannot find the file specified.

Which was fortunately easily solved by re-installing the WHOLE driver package, including the bundled .NET 2.0 runtime. This was quite strange, as .NET 2.0 was already installed on the system.

Just go into add and remove programs in control panel and find Ati software uninstall utility and click change/remove then reinstall bundle from the link.

hope this helps
waspi

So simple right?It worked! Had to completely uninstall .NET and CCC and reinstall..Thanks guys!