Good morning all...
Have made some changes.
Bought new Acer K222HQL Monitor to replace my 12 year old Acer Monitor which only had one plug in the back of the Monitor. This one has All the Plug ins I will need.
So I have eliminated the one Cord Adapter but still have one Cord Adapter going from my Samsung Monitor to the Computer.
Could not find a Cord to go from the Samsung Monitor to the Computer which would plug into the NVIDIA Card without using the Adapter.
The Samsung is 5 years old and is still used as my main monitor.
The employee in the Computer Section at the store said I should not get a large drop in Frame Rates by using this Cord plus Adapter.
The Acer was on Sale so I picked it up.
The NVIDIA card shows up in the FSX Settings so all is well there.
Microsoft Windows 10 & FSX Deluxe/Acceleration
FSX Terrain & Water Settings
-All at Max except Mesh Resolution...
-Mesh Resolution set to 5% one move below MAX Setting
-Scenery Complexity...Very Dense
-Auto-gen Density........very Dense
-Frame Rates set at 30 in FSX...
-General Aviation.......38
-Airport Traffic...........Medium
-Roads...15 & No Boat Traffic...0
Payware:
ORBX...Scenery & Weather
REX.....Textures
FSWC...Flight Simulator Water Configurator set to Steves Settings
Aircraft...Carenado Cessna 185 Wheel Skis
Season is Winter and early AM simulated Cross Country Flight
Left FRAPS on
Now I am just wondering...when I take a Screenshot I Pause the simulated flight...perhaps I am not waiting long enough for the Frame Rates to change...never thought about that ...then I take the simulated flight off Pause and take the Screenshot.
Maybe it is the way I am doing the Screenshots that is the reason for the fluctuation in Frame Rates...shall have another go soon...
Here is how the simulated flight came out as for pictures and Frame Rates:
Comments and Advice most welcome...