EVVFCX wrote:Hi Gary,
Not been on the site for a little while and saw this problem with the 1 & 2 for ATC and you saying the screen just flashed, sounds like you were changing the view but because it was a quick press you didn't see the new view just the display starting to change then back to it's original view.
Having Num lock ON/OFF will do this, if you had set the button to use Num 1 then num lock was off your then changing the view.
As someone has mentioned, don't use the Saitek software, I've not even installed it once, I use registered version of FSUIPC and do the compound button settings as well to get more out of the yoke's buttons, otherwise your only getting one command for each button where you can get three on each with compound settings.
regards
Steve
I thought about that and even thought my keyboard might have a problem since it is wireless but I opened up note pad and made sure that the num lock was working and it was so who knows
The only thing I can think of is some update changed this but have no idea as to which one and when did it change.
The software that I use to make the profiles with has a test feature so you can see what happens when you press a button and when I press the right hand button on my yoke the number 1 comes up.
What ever the reason it was simple to change the profile to use the keyboard 1 rather than the num 1 and it works like it should.
Just cross it off as another one of those strange events that you will never figure out